How should I go about scanning this?

[Falenone]

Hello. I’ve been trying to get this wayspot scanned, It’s a car bumper and a sign above it, It’s quite high up, slightly higher than my height and I’ve been trying to get it to production quality but every time I get poor quality scan, target not visible or scanned from a car. I guess because it recognizes it as a car due to the bumper?

How should I go about trying to get it to good quality scan? Obviously there’s no point in uploading the poor or okay scans as then it will only be experimental at best

[Josh_Niantic]

Hello, thanks for reaching out! An extensive list of the best scanning practices can be found here on the Scaniverse support page. It’s important to move slow & steady while trying to scan from as many different angles & distances as possible. In addition, avoid any sudden changes in movement while keeping the focal point the same throughout the scanning process. If height is the issue, you could try using a selfie stick. Just be sure to apply the same techniques as mentioned before.